BC Acoustique EX888, Руководство пользователя

Страница: 6 / 12

6
① PHONE / HEADPHONES .
Important note: Make sure the volume control is turned
down before connecting or disconnecting headphones.
Listening at high levels can cause permanent hearing
damage.
This Jack plug size 6.35 mm allows connection of stereo
headphones. It is advisable to use a listener with an
impedance between 32 and 600 ohm headphones.
When the headset is connected, the output to the speakers
are then cut.
② MODE .
This function allows you to switch between the operating
modes "triode" and "pentode (also referred ultra linear)."
When the button illumination color is BLUE is that it is in
triode mode, and when he is WHITE is that it is in pentode
mode (ultra linear).
③ DIRECT .
If this function is activated (light signal active), then the
BASS and TREBLE functions are disabled. The purpose of
this function is to shut down the electronic circuit’s tone
control and balance in order to best preserve the purity of
the music signal.
④ BASS and TREBLE .
The button "BASS" setting can act on the relative level of
low frequencies to alter the tonal balance of the sound to
suit your room acoustics and your tastes. The "TREBLE"
button for meanwhile high frequencies.
.
When these buttons are in the middle position, it means
that the tonal balance is not changed. The adjustable range
is ± 10 dB.
+10 decibels knob turned in the direction of clockwise and
- 10 decibels knob turned anticlockwise.
⑤ VOLUME .
This knob adjusts the output volume of the amplifier at the
speaker outputs.
⑥ SOURCE SELECTOR
.
These buttons select the active input of the amplifier and
the signal sent to the speakers, to headphones and Preamp
output and REC LINE. The buttons on the remote control
are identical to those buttons. Once the selected button,
the integrated LED corresponding entry under the particular
input button will turn white.
LINE 1 to LINE 4/BYPASS .
These buttons are used to select sources from the RCA in-
puts (line level) with the same name located on the rear
panel of the amplifier.
OPTION .
Without Optional card: This button selects the listening to
a 5
th
source you have connected to the RCA OPTION
connectors (rear panel).
With Optional card: This button allows you to select the
source to play on your option card. (See notice of the said
option card).
.
Example of option card: Bluetooth card allows you to listen
to your music from your Smartphone.
⑦ ON / OFF BUTTON .
This switch allows shutdown or operation of the amplifier.
Note: 4 rubber blocs are provided in order to raise the unit,
to re-adjust the spacing between two products, providing
better ventilation, reducing vibration and to allowing better
access to the On / Off switch located under the front panel.
Front panel Connections and uses