4
- Some countries do not allow the exclusion or limitation of
incidental or consequential damages or exclusions of implied
warranties. Therefore, the limitations or exclusions herein
may not apply. This warranty gives you specific legal rights,
in addition to other rights which vary from state to state or
country to country.
Warranty
Connections to the amplifier
③ VOLTAGE SELECTOR
IMPORTANT:
Before turning on your amplifier, check that you
have positioned the voltage selector based on your geographic
location: AC115V (USA, etc ...) and AC230V (EU, etc ...). Also be
sure to use appropriate fuse for the selected voltage sector.
Example position voltage selector:
230V for Europe
115V for USA
④ LOUDSPEAKER TERMINALS
Connect the speaker to the terminals marked RIGHT
«+ R» and «R -» ensuring that «R +» is connected to the «+»
terminal of the enclosure and «R -» is connected to the terminal
«-» the same enclosure. Connect the LEFT speaker to the
terminals marked «L +» and «L -» by doing the same.
Make sure that no wires are not insulated can bypass the
speaker outputs. Make sure that the speaker terminals are tight
enough to ensure a good electrical connection. If the terminal
screws are not tight enough, the sound quality may be affected.
Use only dedicated wire to the speaker (a section of 1.5 mm² or
more is recommended especially if the cable length is greater
than 3m).
Important Note:
Check the impedance of your speakers.
When using a pair of speakers, you can use speakers with an
impedance of between 4 and 8 Ohms.
⑤ USB - Upgrade
This USB input is only used to update the amplifier firmware.
⑥ DIGITAL
Your amplifier has a built-in digital-to-analog converter.
Therefore it is possible to connect a digital source (such as most
modern television screens).
To ensure compatibility with all existing types of digital
terminals, the amplifier has an «optical» and a «coaxial» socket.
However this entry is unique and it is possible to listen one
device at a time even if both are connected.
Make sure that the device is not plugged into the mains
before making any connections. It is also recommended to turn
off or disconnect all other devices associated while making
connections to the product.
Connect the speakers to the speaker terminals on the back
and the sources of the corresponding input jacks on the back.
Connect the power cord to the connector on the one hand AC
Mains product and the other to a wall outlet.
IMPORTANT:
Make sure you have set the voltage selector
(①
page 5) to suit your country: INPUT VOLTAGE:
AC115 (USA)
and
AC230 (EUROPE).
Turn the POWER switch ON (② located on the rear panel).
Then press the STANDBY button ① to turn it on.
Press the input button for the source you want to hear ⑩.
Basic instructions
Quick starting guide
WARNING:
Be sure to turn off the power on your product before
making any connections. Similarly it is best to cut the power of
other devices you want to connect to your amplifier.
① AC MAIN INPUT
Once all connections to the amplifier done, plug the power
cable into an outlet. Your amplifier is now ready for use.
② POWER: ON/OFF BUTTON
This switch allows shutdown or operation of the amplifier.
Rear panel
Connections to the amplifier
230V
115V
VOLTAGE SELECTOR 115/230V
VOLTAGE SELECTOR 115/230V
