8
WWW.BBTA.COM.AU
BBT-BC-26CCBH, BBT-BC-26CCDH, BBT-BC-52CCBH
1. BLADE: Circular blade for grass, weed or brush
cutting applications. Harness, metal shield and Bull
Horn Handles/D-Handles are required for blade
operation.
2. DRIVE SHAFT ASSEMBLY: Contains a specially
designed liner, flexible drive shaft.
3. THROTTLE TRIGGER: Spring loaded to return to
idle when released. When accelerating, press
trigger gradually for best operating technique .Do
not hold trigger whilst starting.
4. IGNITION SWITCH: “Slide switch” mounted on
top of the Throttle Trigger Housing. Move switch
FORWARD to RUN and BACK to STOP.
5. SAFETY LEVER: Before acceleration, compress this.
6. BULL HORN/D-HANDLES: These handles can be
adjusted at your convenience for comfort.
7. HARNESS STRAP: An attachment which hangs
the machine on the operator and is adjustable in
length.
8. AIR CLEANER COVER: Contains a replaceable felt
element.
9. FUEL TANK LID.
10. FUEL TANK: For fuel and contains fuel filter.
11. PURGE BULB: Pushing purge bulb (7 to 10 times
before starting) will remove all air and stale fuel
from fuel system and bring fresh fuel to the
carburettor.
12. CHOKE: The choke control is located on the top of
the filter cover. COLD STARTS: Pull lever up to close
choke for cold starts. Push lever down for RUN
position.
13. DEBRIS SHIELD: Mounted just above the cutting
attachment helps protect operator by deflecting
debris produced during the trimming operation.
Do not operate unit without shield.
14. CUT-OFF KNIFE: Trims nylon filament to the correct
length 17cm, head to end of line. If trimmer is
operated without a cut-off knife the line becomes
too long (more than 17cm) the operating speed
will slow down the engine, and will overheat or
damage the engine.
15. NYLON CUTTER HEAD: Contains replaceable nylon
trimming line.
PARTS LOCATION
