bbluv BO137, Инструкция по эксплуатации

Страница: 7 / 24

Kübe
EN
Loop mode
To play all the melodies and repeat, press and hold the
Loop button
E
for three seconds until the next song begins.
The songs will then play one after another.
Repeat mode
To repeat the same melody, press the loop button
E
again.
It will stop playing automatically after 60 minutes. When you
turn the Kübe on again after turning it off manually, it will
remember the last melody played and play it again.
Sound Volume mode
The Kübe has 5 sound levels.Press the Volume Control
button
F
to raise the volume.When you reach
the fifth volume level, press the button again to reset the
device to the first level.Keep pressing the Volume Control
button
F
until
you reach the preferred volume.
Note: The sound and projection modes can be used independently.
Voice Activation mode
To activate this mode, press the Voice Activation
button
H
on the left side until the light turns on and you
hear the sound of a beep. When activated, the device will
switch on automatically if your baby starts crying. When your
baby begins crying, if this function has been activated, both
the light and sound will turn on and play for 5 minutes, after
which the device will enter sleep mode. If your baby cries
again after that, the Kübe will turn on again.
To deactivate this function, press the Voice Activation button on the right side
H
.
Note:
(1) The maximum volume level that will be set when Voice Activation mode is enabled depends on the last recorded level. For
example, if the last saved volume level was 3, the next time the Kübe is activated, it will begin at level 1 and gradually increase
to level 3.
(2) When using Voice Activation mode, both light and sound will activate. It will not be possible to switch them on and off
independently.
7