Output format:
G + 2.00 kg <cr><lf>
N + 1.00 kg <cr><lf>
T + 1.00 kg <cr><lf>
12.0 CALIBRATION
Occasionally the scale should be verified whether it is weighing
correctly by measuring to a known mass.
Zero the scale. Place the mass on the centre of the platform
and note the reading. Calibrate the scale, if necessary.
While in the normal weighing mode, press and hold the
key for 4 seconds.
The display will show “
CAL
” along with the last selected unit.
The unit can be changed by using the
key to calibrate
in kg or lb.
Press the
key. The display will show “
L xx
” where
xx
is
the Calibration weight which is user-selectable.
Use the
key to change the flashing digit and the
key to move to the next digit.
Press the
key to confirm the calibration weight. The
digit stops flashing.
Note:
If the selected mass is less than 10% of the capacity of
the scale, an error message “
CALEr
” will be displayed and the
scale will return to zero. Repeat the process correctly.
9
Place the correct calibration mass as selected by the user at
the centre of the pan.
Press the
. The display will return to weighing mode.
Note:
If the mass loaded is more than ±20% of the factory
calibration reference then an error message “
CALEr
” will be
displayed and the scale will return to weighing without
calibration being saved. Repeat the process correctly.
Remove the weight. Verify the scale is calibrated correctly.
Repeat the process, if necessary.
13.1 USER PARAMETERS
The scale can be set as desired by the user to control the weighing
operation.
Switch off the scale.
Hold the
key and then press the
key
momentarily. Release the
key. The display shows the
first parameter - auto power off.
To exit the parameter setting at any time, press the
key.
To scroll through the user parameters, press the
key
(which will advance to the next parameter).
To return to normal weighing, turn the scale off and back to on
again or press the
key.
10
