4
4
5
2
3
1
The sealant should overflow all the way round the sealing
edge.
Contact end pieces can only be mounted and used once. Reliable contacting and sealing are not guaranteed during disassembly
and re-assembly!
The sealant is highly adhesive; dust and dirt particles will stick
to it immediately on contact. Therefore, once you have unpacked
a contact end piece and removed the protective cover, you
should proceed with particular care and ensure that the working
environment is kept clean and tidy until it is pressed into place.
Hold the profile shank at an acute angle and check for
axial alignment when pressing the contact end piece in.
Flexible adhesive strips are supplied with the contact end
pieces. Apply a strip of adhesive to the center of the sealant
from above and over both sides, and then press down well to
ensure that the sealant is covered.
2. Mounting contact end pieces
Remove protective plug, if present