ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
t
A Phillips Head screw driver is needed to
assemble trampoline/enclosure. However, a
screwdriver is not provided.
t
Assembly requires two persons. Keep
children away from the trampoline/enclosure
until it is fully assembled.
t
Use gloves to protect your hands from pinch
points during assembly.
t
The assembly steps refer to parts by their descrip-
tions and key numbers (see the PART LIST on
page 11). If a part is missing, see ORDERING
REPLACEMENT PARTS on page 11.
TRAMPOLINE/ENCLOSURE PLACEMENT
1. Place the trampoline/enclosure on a level surface
before use.
3. Use the trampoline/enclosure in a well-lit
area. Artificial illumination may be required for
indoor or shady areas.
4. Secure the trampoline/enclosure against
unauthorized and unsupervised use.
5. Remove any obstructions from beneath the
trampoline/enclosure.
6. The trampoline enclosure is only to be used
as an enclosure for a hexagonal trampoline.
1.
1a.
1b.
1a.
1b.
You have now assembled one leg sections. Repeat the step
to assembled remaining sections.
4
WARNING!
Please read all of the directions prior to assembly.
Inspect the trampoline and enclosure to make sure all parts are included. If any worn, defective or
missing parts are found, please contact customer service immediately.
Make sure you wear gloves to protect your hands from pinch point and sharp point during installation.
Be careful where you place your hands; the springs and frame joints can pinch.
Check all screws for tightness and tighten up if loose.
Check all sharp edges and replace when required.
1
1
1
1
1
1
2
2
2
2
2
2
3
3
3
3
3
3
1
1
2
2
7
7
14
14
3
3
8
8
Make sure you understand the information in the box at the top of this
page before you begin assembling the trampoline.
Lay two top tubes (1) on the ground as shown. Make sure there is a
POD-connector(2) on each Top tube. Insert the top tube into the
POD-connector as picture 1a shown. Insert the leg(3) with leg foam
sleeve(7) into POD-connector(2), tighten a Self-tapping screw(14) into
small hole in the POD-connector(2). Then cover the plastic foot pad(8)
into leg(3).
