Bayliner Ciera, Руководство пользователя

Страница: 32 / 52

26 Chapter 2: Components/Systems
3055 EL Ciera Sunbridge • Owner’s Manual Supplement
Marine Head System & Waste Tank
Your boat comes equipped with a marine head (toilet) and
waste holding tank system. Be sure to read the manufacturer’s
operation and maintenance manual (included in your boat’s
owner’s packet).
• The marine head installed on your boat uses seawater to
flush waste from the toilet. The seawater intake valve (sea-
cock) is located in the port forward side of the engine room.
• Waste is routed directly from the head to the holding tank.
• The holding tank is plumbed to a fitting on the deck for
dockside pump-out and to a macerator pump for pumping
waste overboard (where regulations permit). The macerator
pump switches are located at the helm. To activate the
pump, you must press both of the macerator switches
simultaneously.
• You can determine the content level of the holding tank by
looking at the tank through the hatch on the cabin entry top
step (with the trash can removed). It is advisable to empty
the holding tank at every opportunity.
• If you are unable to pump water into the bowl, the probable cause is debris in the pump diaphragm. To remedy
this, shut off the seawater intake valve (seacock) and dismantle the pump. The pump is generally held together
with six screws (the design is simple and the problem will be obvious when the pump body is split open).
• To winterize the head, shut off the intake seacock and pump until the bowl is dry. Remove the drain plug in the
base and pump again to remove all of the water. Do not fill the bowl with anti-freeze. The intake seacock should
be left closed while the boat is underway or whenever the boat is left moored in the water.
Operating the manual flush marine head:
1. Open the head’s seawater intake valve (seacock).
2. Before using the head, pump enough water into the bowl to wet the sides.
3. After use, pump until the bowl is thoroughly cleaned. Continue pumping a few more times to clean the lines. If
excess waste causes the water to rise in the bowl, stop pumping until the water recedes.
Standard Head System Routing
WASTE PUMP-OUT
FITTING ON DECK
WASTE PUMP-OUT FITTING LOCATION
NOTI C E
Check with local authorities for regulations regarding the legal use of marine head systems.
HEAD
SEAWATER
TO HEAD
WASTE FROM HEAD
TO WASTE TANK
SEAWATER INTAKE
VALVE (SEACOCK)
AFT
TO PUMP-OUT
FITTING ON DECK
TO THRU-HULL
MACERATOR
HOLDING
TANK VENT
WASTE HOLDING
TANK