BAYKAL HGL C Series, Руководство пользователя

Страница: 92 / 104

BAYKAL
EDITION NO : HGL SECTION :
DATE OF ISSUE : November 2009 PAGE : 92
e) Lift up the beam.
f)
Move down the cutting beam such that top and bottom blades are edge to edge
on the left side where the first adjusting bolts are. Check the blade gap by a
filler gauge. If the gap is greater than 0.1 mm, loosen up the blade fixing bolts
(11-25).Push-in the fine adjusting bolts (11-29) to obtain a blade gap of 0.1
mm and tighten the nuts (11-30). Re-tighten the bolts
(11-25). If the gap is smaller than 0.1 mm, loosen up the nuts (11-30) and the
bolts (11-29). Screw up the blade fixing bolts (11-25) to obtain a blade gap of
0.1 mm. Tighten the bolts (11-29) and the nuts (11-30).
Figure 6.6.7.1
g)
Repeat the procedure in (f) for all fine adjusting bolts alongside the blade
length from left to right.
h) Test the cut quality by shearing a 1 mm thickness material. Where the cut is not
burr-free alongside the blade length, repeat the procedure in (f) to attain a fine
shearing quality.
Make sure that the blades do not overlap, when fine-adjusting the
top blade.
Top blade fixing bolts
Adjustment nuts