Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.baycoproducts.com
INS-SL-655-17
SAFETY / CARE
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY IT SELF AS DAMAGE
OR INJURY MAY OCCUR FROM EXCESSIVE REWIND SPEED.
y
Adjust the cord stop to hold the receptacle at the desired length when the cord is
retracted.
y
Before cleaning the reel always unplug from the power source.
y
Clean the outside of the cord reel only. Use a soft cloth with mild detergent. Do not
use petroleum based to clean the cord reel. Never immerse the cord reel or receptacles
or work lights in water. Dry thoroughly before attempting to reattach to power source.
WARRANTY
1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship
and materials to the original purchaser for 1 year from the date of purchase, and includes
the LEDs, housing, lenses, electronics, switches, rechargeable batteries and chargers.
Bulbs (other than LEDs) are covered for 90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective. This is the
only warranty, expressed or implied, including any warranty of merchantability or fitness for
a particular purpose.
For a complete copy of the warranty, go to www.baycoproducts.com/bayco-product-
support/warranties. Retain your receipt for proof of purchase.
Instruction Manual
SL-655
ELECTRICAL RATING - 120 VOLTS 60 HZ
CAUTION
y
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK AND FIRE - PULL
PLUG WHEN SERVICING
y
CAUTION:
DO NOT use this cord reel in explosive atmospheres, near flammable
liquids, or where explosion proof lamps are required.
y
DO NOT
use in the proximity of vehicles or equipment when there is a risk of
flammable liquids coming into contact with the hand lamp
y
DO NOT
immerse in water
y
DO NOT
use in areas where water can accumulate or in rain or mist
y
CAUTION:
Risk of Electric Shock – For Light Duty Dry Location Use Only
GENERAL USE CORD REEL ONLY. NOT FOR HARD USE. FOR INDOOR DRY
LOCATION USE ONLY FOR LIGHT DUTY RESIDENTIAL USE ONLY
WARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONS
CAUTION: DO NOT USE IN HAZARDOUS LOCATIONS AS REQUIRED BY THE
CANADIAN ELECTRICAL CODE, PART I
IMPORTANT SAFETY INSTRUCTIONS
This product has a polarized plug (one blade is wider than the other). As a safety
feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use
with an extension cord unless the plug can be fully inserted. Do not attempt to defeat this
safety feature.
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY ITSELF AS DAMAGE
OR INJURY MAY OCCUR FROM EXCESSIVE REWIND SPEED
CAUTION: DRYWALL WILL NOT HOLD THE WEIGHT OF THE REEL ASSEMBLY
CAUTION: READ AND UNDERSTAND MOUNTING INSTRUCTIONS BEFORE
ATTEMPTING INSTALLATION AND USE OF THIS PRODUCT
OPERATION
y
To operate, plug into a 120 Volt 60 Hz grounded outlet.
y
Pull out desired length of cord. Notice a clicking noise when pulling. Cord will stay
at the desired length during clicking and rewind after a pull past the clicking noise.
Extended length when retracted can be adjusted by sliding plastic ball to desired
position.
y
Move I-O switch to “I” position. Lamp may flash several times before lighting,
especially in cold weather. Turn off by moving switch to “O” position.
CAUTION: DO NOT ALLOW CORD TO RETRACT BY ITSELF AS DAMAGE TO
CORD END FITTINGS MAY OCCUR FROM EXCESSIVE REWIND SPEED.
TO CLEAN OUTSIDE OF UNIT
Unplug the unit before cleaning and dry thoroughly before re-using. Use a soft cloth
with mild detergent. DO NOT use solvents such as gasoline, turpentine, etc., to clean
the unit. NEVER immerse the reel or cord end fittings (receptacles or lamps) in water.
MOUNTING
Ceiling or Wall Installation
y
Select a location within 2 feet of an electrical outlet. The outlet for a garage door
opener is desirable.
y
Drywall will not hold the weight of the reel assembly, so locate a ceiling joist or
wall stud and using the mounting bracket as a template, mark the holes so they are
centered on the ceiling joist or stud.
y
Attach the mounting bracket to the stud using the 2 wood screws provided.
y
Align the holes on the side of the reel with the holes in the side of the mounting
bracket and insert the pin.
y
Place the retaining ring on the pin and twist until the entire ring is through the hole in
the pin.
DO NOT operate this reel without the retaining ring in place on the pin.
