Digital Steam Steriliser with Dryer
EN
8
Preparing for sterilisation
■
Before sterilising bottles and accessories, thoroughly wash them with a bottle brush and accessories in hot
water using a detergent suitable for children, rinse thoroughly and allow to dry .
Assembling the steriliser
■
Stand the steriliser on a horizontal and stable surface .
■
Take off the lid of the steriliser
A
1
and take the stand
A
2
out of the base
A
3
of the appliance .
■
Using the measuring cup or, for example, a baby bottle, measure out exactly 120 ml of tap water and pour it
directly on to the stainless steel heating plate inside the appliance . The water level should never rise over the
line marked as "MAX 120ml" located inside the base of the steriliser
A
3
above the stainless steel heating plate .
■
Place the stand
A
2
into the base
A
3
.
■
Place the baby bottles and accessories such as nipples, dust caps, screw rings, etc . on to the holders in the
stand facing downwards so that they do not fill up with water, with the baby bottles in the lower position in
the stand
A
2
and the accessories in the upper position of the stand
A
2
.
Note:
Make sure that all parts intended for sterilisation have been completely disassembled .
■
Place the lid
A
1
on to the base of the steriliser
A
3
so that the arrow on the lid points at the arrow on the
base of the steriliser
A
3
. Make sure that the lid
A
1
has properly adhered to the base
A
3
. Never turn on
the steriliser without putting on the lid with handle
A
1
.
■
Insert the power plug into a power socket .
■
Now the appliance is ready for operation .
■
Press the On/Off button
B
4
on the control panel
A
4
of the appliance . The LCD display will show the initial
value 00:00 . Select the desired function as described in Chapter Operation below . If you do not select any
function after pressing the On/Off button
B
4
, the appliance will automatically turn off after approximately
1 minute .
Operation
!
Attention:
Never use the appliance without water inside the steriliser!
■
The steam that is released during the sterilisation process is hot . Keep your hands away from the appliance
during the sterilisation process .
Automatic sterilisation and drying
■
Assemble the steriliser according to the instructions included in chapter Assembling the steriliser .
■
After pressing the On/Off button
B
4
, select the Automatic sterilisation and drying function
B
5
on the
control panel
A
4
of the appliance . For 45 minutes of drying after the sterilisation process, press the
Automatic sterilisation and drying function
B
5
once, for 60 minutes of drying press the button twice and for
30 minutes of drying press it three times .
■
The automatic sterilisation and drying will commence 3 seconds after the last time the button is pressed .
■
When the sterilisation process begins, the LCD display will show the approx . 11-minute countdown of the
sterilisation cycle .
■
The end of sterilisation is indicated by a sound signal . Then a 3-second pause follows and the automatic
drying function will start and will run for the length of time set by pressing the Automatic sterilisation and
drying button
B
5
as described above . The timer
B
7
on the LCD display will show the countdown in
seconds until the initial value of 00:00 is reached .
