Bay Tek Games Connect 4, Руководство по обслуживанию

Страница: 26 / 39

26
Bonus
Lights do
not come
on at end
of game.
Bonus Feature not enabled in
menu.
Faulty cable from bonus light
boards in top back of game to
main board in front of game.
Faulty center bonus light board
Power comes into this board.
Faulty main board.
Enter menu and set “Bonus Type” to “One Hit Bonus”
Check wiring continuity from light boards to main Board.
(AACE4625, AACE4607, AACE4600) Check for pinched,
broken or disconnected wires. Replace as necessary.
Replace center bonus light board. (AACB4602) Refer to
Back of Game Wiring Diagram.
Replace main board. (AANEWGEN1-PJ)
All Bonus
Lights
stay ON.
Surface mounted transistor
blown on main board caused
by 12 Volt dead short on one of
the bonus light circuit boards.
Locate 12 Volt short. Refer to Back of Game Wiring
Diagram. Repair cable (AACE4624) or replace bonus light
board (AACB4602)
Replace main board. (AANEWGEN1-PJ)
Some
Bonus
Lights
stay ON.
Faulty bonus light circuit board. Refer to Back of Game Wiring Diagram.
Replace bonus light board (AACB4602)
Arc Light
Boards do
not come
on, or
stay on.
Cable is plugged into wrong
socket.
Faulty cable from Arc Light
Board to Controller Board.
Faulty arc light boards.
Faulty Controller Board.
Refer to Back of Game Wiring Diagram, and Connect Four
Playfield Wiring Diagram for proper connection.
Ensure cable is secure, swap cable to isolate problem.
Replace as needed. (AACE4624)
Swap arc light boards to isolate problem, replace if
needed. (AACB4603)
Ensure Dip’s 3 & 4 are ON for top board. Swap boards to
isolate problem, replace if needed. (AACB4600)
Purple or
Pink lights
on
playfield.
Dipswitches set wrong on
Controller Boards
RGB Light Board Faulty
One of power supplies is faulty.
Controller Board faulty.
Refer to Connect Four Playfield Wiring Diagram - make
sure that 2 lower boards have Dip 4 ON,
and top board has Dip 3 & 4 ON
Refer to Target Wiring Example- Cables can be swapped
into different sockets to isolate problem to rear controller
board or front RGB Light Board.
Refer to AC Power to Game - If one power supply is faulty,
it will not power RGB board correctly.
Replace power supply if needed. (AAPS4600)
Refer to Back of Game Wiring Diagram, and Connect Four
Playfield Wiring Diagram - Controller boards can be
swapped to isolate problem.
(Make sure dips are set correctly)
Replace controller board if needed. (AACB4600)
Symptom Probable Cause Remedy
TROUBLESHOOTING GUIDE