24
Dollar Bill Acceptor
not functioning.
Caution – 110
Volts AC
Cable can be
moved between
left and right sides
to isolate problem
to DBA.
Ensure bill acceptor has 110
Volts AC.
Dirt or debris in acceptor slot.
Ensure acceptor dipswitch
is set to “always enable”
Pinched, broken, or discon-
nected wiring.
Bill acceptor problem.
Acceptor should cycle stacker at game
power up. If not, check cable connections
to power strip.
Clean with bill reader cleaning card(A5CC9000)
There are dips on side of acceptor.
Set to “always enable”, not harness enable
Check wiring from bill acceptor
to main board.
Repair or replace
wiring harness.
(AACE4626, AACE4627, AAACE4602)
Refer to troubleshooting section of dollar bill
acceptor manual included with this game or the
diagnostics label of the back of the unit.
Monitor not working.
Power down, wait
10 seconds and
power up again.
Error on screen at power up.
Display stops at "No bootable
device - insert boot disk and
press any key"
Re-Boot game to see if problem
still exists.
Flash drive unplugged from board or faulty.
Re-seat and
t
ry power on to game again.
Insert USB stick in different slot on motherboard
Replace USB software stick.
Replace motherboard. (AAMB7)
Monitor says “NO SIGNAL” for 5
seconds after power-up.
Then dark.
Refer to Monitor/Motherboard Power Supply
Diagnostics Section
Monitor has nothing at all on
power up.
Power cable unplugged from
monitor.
Faulty monitor.
Ensure power is plugged into back of monitor,
down to power strip.
Replace monitor. (A5MO2200)
Symptom
Probable Cause
Remedy
TROUBLESHOOTING GUIDE
Monitor does not
come back up after
a power loss
Voltage variation in power
network
Turn off the power strip, wait 30 seconds, then
turn power strip back on
