Bay Networks Remote Annex 4000, Руководство по установке оборудования, Страница: 121 / 162

4-15 Remote Annex 4000 Hardware Installation Guide
Chapter 4 Troubleshooting Procedures
Unless otherwise stated, if you are using a SLIP interface to boot the
Remote Annex 4000, obtain the following information using the
slip
command:
❑
Whether the port is configured as a SLIP interface.
❑
The default Internet address for the SLIP network interface.
❑
The default Internet address for the remote end of the
SLIP connection.
❑
The default Internet address for the load/dump host (this
must be specified if the remote end is a gateway and not a
load host).
❑
Whether the SLIP network interface is included in the load/
dump interface list (use the sequence command).
❑
The baud rate.
❑
The number of stop bits.
❑
The parity.
You can use the defaults for the name of the image file containing the
Remote Annex 4000’s software and the address of the preferred load
server host. If the value for the image name is incorrect, the Remote
Annex 4000 cannot boot. Correct the name using the image command.
If the address for the preferred load server host is incorrect, the boot
takes longer, since the Remote Annex 4000 has to broadcast for a host.
Correct the load host’s address using the addr command.
Confirm that the Remote Annex 4000 boot parameters are correct by
using the appropriate ROM Monitor commands. Modify any boot
parameters that are incorrect or missing. Boot the Remote Annex 4000
either by entering the boot command at the console, or by holding
down the Test button until the Power LED blinks rapidly and then
releasing the Test button.