– 13 –
USING THE SP600 WATER METER
Change Units (English/Metric)
When the Water Meter is
fi
rst powered up, press CHANGE UNITS to select the English units (Fahrenheit
and Pounds) or Metric unit (Celsius and Liters). If the unit of measure DO NOT change, the CHANGE
UNITS key is locked. See Locking and Unlocking the Change Units on page 14 to unlock.
1. Press CHANGE UNITS to select Fahrenheit or Celsius.
2. Press CHANGE UNITS to select Pounds/Ounces or Liters/Centiliters.
The Units can be changed individually as follows:
Change Temperature Unit:
1.
Press
SET
TEMP.
2. Press CHANGE UNITS to select Fahrenheit or Celsius.
3. Enter a new temperature setpoint.
Change Amount Units:
1.
Press
SET
AMOUNT.
2. Press CHANGE UNITS to select Pounds or Liters.
3. Enter a new amount setpoint.
NOTE:
Units cannot be changed if the Water Meter is
fl
owing water to either the bypass or delivery lines,
or is paused in this process. The Water Meter automatically saves the unit change on the power down.
Setting Water Temperature, Water Amount and Dispensing
1.
Press
SET
TEMP.
2. Enter desired temperature on the numeric key pad. The water temperature value is displayed in the
WATER
TEMPERATURE window.
3. Hook the dispensing hose over the rim of the container to which the water is to be delivered.
4.
Press
SET
AMOUNT.
5. Enter the desired water amount value on the numeric key pad. The entered value is displayed in the
WATER AMOUNT SETTING window.
NOTE:
The value for ounces must be 15 or less; otherwise, the OUNCES display will blink and no water
will dispense.
6. When the water reaches the selected temperature it will automatically switch delivery from the bypass
line to the delivery hose.
7. Place the dispensing hose on the hook, located on the side of the water meter.
NOTE:
Do not drain the remaining water from the hose.
