Baxi 961, Инструкция для установщика и владельца

Страница: 49 / 56

OWNER GUIDE
Page 49
Lighting with a taper.
Important: When lighting with a match
or taper be very careful not to place
naked flames by the plastic / rubber
coated leads.
In the unlikely event of failure of the
ignition spark, the pilot can be lit by a
taper or long spill. To do this, remove the
lower ash pan casting then insert a taper
or spill as shown in figure 4. Operate the
slide control as described previously.
CLEANING YOUR FIRE
To maintain the high performance and quality finish of your fire please follow these
guidelines:
Before attempting to clean the fire, please remember to turn off the fire and wait for
the appliance to cool completely. The fire will retain heat for some time before
cleaning can begin.
If any pieces of debris are found in the firebox, have the chimney inspected before
further use.
Glass and Metal parts.

Clean the glass and metal parts with a slightly damp cloth and then dry.

Do not use abrasive cleaners as these will scratch the fire surface.
Window assembly.
Removing and cleaning the window assembly.
Removal of the window assembly is only necessary if you wish to clean the rear of the
window or access the ceramic components. The window assembly can be cleaned
with a mild detergent and water. Glass cleaner can also be used. Any stains on the
glass can be removed with a non-abrasive cleaner such as a ceramic hob cleaner.
Never use abrasive cleaners. Clean the window carefully in accordance with the
instructions supplied with the cleaner.
Note:
When removing and fitting the window assembly care must be taken to ensure
that the bottom of the glass is lifted high enough to clear the front ceramics and
prevent damage to them. Ensure that the inside face of the window assembly is
clean and free of fingerprints.
©
Baxi Heating U.K. Limited 2010.
Figure 4. Lighting with a taper