Baxi 940, Инструкция для установщика и владельца

Страница: 19 / 48

Page 19
©
Baxi Heating U.K. Limited 2010.
6. IGNITION CHECK
Before attempting to install, it is worth checking that the electronic ignition system
performs satisfactorily.
Fit the battery to the ignition block located
below the burner tray at the left side (See figure
8). The locations for the +ve and -ve terminals
are marked on the battery holder.
Rotate the control pivot bracket clockwise as far
as it will go and hold in this position (See figure
9). This should close the ignition circuit and
sparks should be seen tracking from the
electrode pin to the pilot tip (See figure 9).
If there are no sparks
make the following
checks.

Check condition of
battery and that it is
correctly fitted.

If the above is
satisfactory, check the
ignition circuit and
components - see
section 16 which is the servicing and parts replacement section in this guide.
7. GAS SUPPLY CONNECTION
A nut and olive are provided for an 8mm pipe inlet connection to the ‘T’ connector at
the bottom front of the appliance. The ‘T’ connector can be rotated to allow a
connection from any direction and includes a valve for isolating the gas supply and a
pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used.
Concealed Supply Pipe Connection.
If a concealed connection from inside the fireplace is required then , before the
appliance is fitted into the fireplace it will be necessary to extend the supply line so
that it will project through the hole in the back of the convection box and run to the ‘T’
connector at the front. The pipe run from the supply line up to the rear opening in the
convection box must be kept away from the area which will be taken by the
convection box when it is installed (See figure 4).
Note that the centre of the appliance inlet ‘T’ connector is 25mm above the fireplace
floor. The inlet ‘T’ connector should be fitted to the supply pipe at this stage.
Figure 9. Slider control
Figure 8. Fitting the battery
INSTALLER GUIDE