Important Electrical Safety
The heater must
not
be located in front of or under an electrical socket, the socket must
always be accessible in order to disconnect the heater from the electrical supply for
maintenance and cleaning.
Important! This heater must be earthed.
!
The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm² 3 core
cable.
!
The wires in the cable are coloured in accordance with the following code: -
Live =Brown
Neutral = Blue
Earth = Green /Yellow
!
The electric supply must be safely routed from
the heater to an electrical socket.
Moving the Cable
At the base of the heater you will find the electric
cable which runs through a rectangular plastic cable
guide. The cable can be moved to the opposite side
if required. To do this please see below:
1.
To open the cable guides push and lift the tab on
the bottom of them and the cable guides will open
(See figure 1- Item 2).
2.
Place the cable into the opposite guide and close
the bases.
If the electric cable is damaged, to avoid a hazard it
must be replaced by a Baxi Fires Division authorised
service agent, or similarly qualified person
(See page 17).
All external wiring between the heater and the
electrical supply shall comply with current IEE
regulations.
Fascia support brackets.
As supplied the fascia support brackets may be
flat against the heater body. Using a suitable tool
or gloved hand bend the brackets as in figure 2.
Page 6
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 2. Fascia support brackets
Figure 1. Moving the cable.
Item 1
Item 2
