floor level.
Fitting the heater.
1.
Decide the location
of the heater.
2.
If the heater is to be
fixed in an elevated
position (i.e. above
hearth or finished floor
height) then the lower
support bracket needs
to be secured to the
rear bottom of the
heater. To do this use
the black screw
provided (See figure
10).
3.
Supplied with the heater is a length of self-adhesive
foam strip. Remove the backing paper and locate the foam
strip along the bottom of the heater as in figure 11. This
foam strip prevents light from the rear of the heater
showing below the heater.
4.
If fitting to a conventional brick wall then use the outer
slotted holes in the bracket. If fitting to a plasterboard wall
that has a wooden frame behind it then use all four fixing
holes in the bracket. This is required to spread the load.
Mark the positions of the hanging bracket
holes on the wall.
5.
Drill the marked positions using a suitable
sized drill bit for the chosen fixings.
6.
Insert the wall plugs / fixings and secure
the bracket to the wall using suitable screws.
7.
Hang the heater body on the hanging
bracket. There is a electric cable slot on both
sides of the spacer frame. If the heater is
located on a hearth then pass the electric
cable through the required slot.
Page 11
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 11.
Figure 10.
Figure 9. Hanging bracket heights from finished floor / hearth
