5 of 10
Any reproduction, distribution, modification, or dissemination of these instructions without written permission from Bavarian Soundwerks is
expressly forbidden and a violation of international copyright law. Any violation will result in prosecution to the full extent available under
the law!
© 2006 Bavarian Soundwerks, LLC.
2195 Defoor Hills Rd., Suite D, Atlanta, GA 30318
P: 404.963.8857 |
www.bavsound.com
Front Midbass Wiring Connections:
In order to make the wiring connections on the new midbass drivers, we’re going to use the existing factory
plugs. We’re just going to slide the terminals on the end of the wiring attached to your new speaker into the
factory plugs that you removed from the factory speakers. Here are a few photos to illustrate the process:
Driver Door
Blue w/White Stripe (+)
Red
Blue w/Brown Stripe (-)
Connects to
Black
Passenger Door
Blue w/Red Stripe (+)
Red
Blue w/Brown Stripe (-)
Connects to
Black
Rear Speaker Removal/Installation
1. First look underneath the armrests on the side panels on either side of the vehicle. You will see two
holes there. Inside are 8mm bolts that secure the panels to the vehicle. Remove these. We have
also seen these as Torx T20 bolts, but they may be another type.
2. Pull the side moldings from the door jams back, and place your fingers behind the panel containing
the speakers. Firmly pull towards you, and the panel will release itself. Now, slide the panel down
and toward the front of the vehicle. Unplug the tweeter.
