Baumuller b maXX BM2500, Руководство по эксплуатации

Страница: 313 / 822

Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
313
of 820
4
170.4
Task status
This parameter shows which task(s) of the controller PLC are active or which task was
active since the last start command. So it can be recognized that write accesses took
place and the correspondent POU was executed.
Mapping from bit to controller PLC task see parameter Task control word (
Z
170.3
–
).
Specified bits can be set to 0 by writing a new mask.
The correspondent bit is set cyclically at cyclic tasks
When writing the parameter the value is not written directly to the parameter, following is
valid:
New parameter value = logical AND operation of

previous parameter value AND input value
170.5
Run time default task
This parameter shows the execution time of the default task in µs.
170.6
Translation control
Control word to translate the PLC intermediate code to executable code. By default, this
parameter is handled by ProProg V5. After loading the PLC project in the controller a "1"
must be written in this parameter to start the internal translation of the project.
170.7
Cycle time default task
Execution time of the default task including interrupts from other tasks with higher priority
in the controller.
170.10
Project name
This parameter shows the name of the active project in the controller.
Bit no. Meaning
0 A rising edge starts the translation of the loaded project.
1 A rising edge effects that the project in the controller is deleted.
15 ... 2 Reserved