Baumuller b maXX 1000, Руководство по параметрам

Страница: 24 / 210

Parameter description
Parameter manual b maXX
®
1000
Document no. 5.07004.03 Baumüller Nürnberg GmbH
24
of 208
4.3
P0036
This parameter sets the mid-point frequency of the V/f curve if
Z
P0800
–
= 0.
With this setting, the V/f ratio between minimum frequency and mid-point frequency can
be determined. This parameter must be equal to or greater than minimum output frequen-
cy
Z
P0038
–
and equal to or less than maximum voltage frequency
Z
P0061
–
. This set-
ting is invalid in vector control mode
Z
P0800
–
= 1.
The settings have to meet the condition of
Z
P0038
–
≤
Z
P0036
–
≤
Z
P0061
–
.
Also see
Z
Figure 8
–
on page 26.
P0037
This parameter sets the mid-point voltage of any V/f curve if
Z
P0800
–
= 0.
The maximum value depends on the b maXX
®
used, up to 255.0 V for single-phase de-
vices and up to 510.0 V for three-phase devices.
With this setting, the V/f ratio between minimum frequency and mid point frequency can
be determined. This parameter must be equal to or greater than minimum output voltage
Z
P0039
–
and equal to or less than maximum output voltage
Z
P0053
–
. This setting is
invalid in vector control mode
Z
P0800
–
= 1.
The settings have to meet the condition of
Z
P0039
–
≤
Z
P0037
–
≤
Z
P0053
–
.
Also see
Z
Figure 8
–
on page 26.
P0038
This parameter sets the minimum output frequency of the drive if
Z
P0800
–
= 0.
This parameter must be equal or less than mid-point frequency
Z
P0036
–
. This setting is
invalid in vector control mode
Z
P0800
–
= 1.
The settings have to meet the condition of
Z
P0038
–
≤
Z
P0036
–
≤
Z
P0061
–
.
Also see
Z
Figure 8
–
on page 26.
P0036 Mittelfrequenz Fmid 0.10 to 600.0 Hz
EE Mid-point frequency (Fmid) 1.50 Hz
STOP BM_u_MidPointFreq 100:1 Hz -
P0037 Mittelspannung Vmid 0.1 to 255.0 V or
0.1 to 510.0 V
EE Mid-point voltage (Vmid) 10.0 V or 20.0 V
STOP BM_u_MidPointVolt 10:1 V -
P0038 Minimale Ausgangsfrequenz Fmin 0.10 to 600.0 Hz
EE Minimum output frequency (Fmin) 1.50 Hz
STOP BM_u_MinOutFreq 100:1 -