Baumr BCX720 Скачать руководство пользователя

Страница: 27 / 52

Petrol Powered Pole Tools

E&OE

Operation

Petrol powered pole tools and attachments are high-speed, fast-cutting equipment

with exposed blades that can cause serious or fatal injury if not used correctly or

without taking proper safety precautions.

It is extremely important that you read and fully understand

the information in this section and all other safety warnings / recommendations and usage

instructions before using the equipment

. • Always wear suitable protective clothing and equipment when

using the machine. • Inspect the machine before each use and check for wear or damage. If the machine is

damaged, have it inspected and repaired at an authorised service centre before using it again. • If you

experience excessive vibration from the machine during operation, this may indicate wear or damage. It is

recommended to have it inspected and repaired before using it again. • Be aware that once the engine is

running, the cutting blades will be rotating and parts of the machine may be extremely hot. • For chainsaw

attachments, ensure that the saw chain is

correctly tensioned

and the chain drive cover nut is properly

tightened before use and during cutting. • Always release chain tension after finishing work to prevent

damage through over-tension as the saw chain cools and contracts.

When the engine is idling (slowest continuous running speed), the clutch should disengage, preventing the

cutting attachment from being rotated. As engine speed increases, the clutch engages and rotates the

cutting attachment. Note the following recommendations:

•

Operate the engine at full speed when cutting, particularly when using the chainsaw attachment.

•

When using the chainsaw attachment, cut using the underside of the chain bar – NEVER use the nose

or top of the chain bar. If in doubt, do NOT cut – seek professional advice.

•

To use line feed action of the grass cutting "bump" head, tap it quickly against the ground while it is

spinning – line will feed out through the spinning action. Excess line will be cut by the trimming blade.

•

Always use the strap, over the shoulder, and adjust it so the tool is comfortable to hold and operate.

•

Always use both handles to hold the tool steady.

Using the Throttle and Adjusting Engine Speed

The throttle trigger (

) is used to adjust the engine speed, which in turns controls speed of the cutting

attachment. To adjust the throttle, grip the throttle handle (

) so that the throttle safety switch (

) is pushed

in – this allows the throttle to be adjusted – squeeze to increase engine speed. The throttle may feature a

limiting screw (

) that stops it from being opened further or a throttle lock (

) that when pressed in conjuction

with the trigger then released, locks at full throttle until the

trigger is pulled again. Note the following:

•

The throttle safety switch must be pushed in, in order to

adjust the throttle. When the throttle safety switch is

released it is not possible to adjust the throttle.

•

It is recommended to set the limiting screw (if

equipped) when an effective cutting speed is attained.

Generally, most cutting attachments are most efficient

at full engine speed. Turn the screw right to reduce the

throttle opening limit (slower speed). Turn the screw left

to increase the throttle opening limit (faster speed).

Straight Handle

Bull-Horn Handle

BAUMR-AG BAUMR-AG BAUMR-AG BAU