Baumr-AG SS16 Скачать руководство пользователя

Страница: 9 / 15

Scroll Saw - SS16

E&OE

Operation

Risk of injury when operating the machine. Always use caution when handling the work-
piece. • Risk of injury when handling saw blades. Use caution and wear protective gloves. •

Ensure that the blade is correctly installed and adjusted before using the machine. • Do NOT attempt to cut
materials that are not suitable to the cutting speed of the machine and blade type. For example, hard metals.
• Know the condition of the machine. If any part is missing, damaged, or does not operate properly, replace
the component before use. • Properly protect your body including your eyes, hands, face, and ears. • Do not
cut a work piece too small to be held safely.

• Use supplied or recommended accessories only. Follow the

instructions supplied with the accessory. The use of improper accessories may cause risk of injury and void
any warranty. • Do not reach under the scroll saw table when the motor is running. • Switch the machine OFF
and disconnect it from the electrical supply before changing the blade, performing maintenance or making
adjustments. • Make sure the switch is OFF before plugging in the power cord to an electric outlet. • Always
hold the work-

piece firmly against the table. • Always feed the work-piece into the machine at the rate the

saw will cut. • Do not start the machine with the work-piece touching the blade. • Use caution when cutting
round or irregularly shaped work-pieces. Round items may roll and irregularly shaped work pieces can pinch
the blade. • Make sure the table is locked into position before starting the machine. • Do not use dull or bent
blades. • When cutting large work-pieces, make sure the material is supported at table height. • If the blade
jams, switch the machine OFF and disconnect it from the electrical supply. Jams are usually caused by
sawdust filling the cut. Wedge open the work-piece just enough to back out the blade, then clear the cut

General Operational Recommendations

A scroll saw is basically a curve-cutting machine. It can also be used for straight cutting and bevelling or
angle cutting operations. Read and understand the following before attempting to use the saw.

•

There is a learning curve for each person using this saw. During that period, it is expected that some
blades will break until you learn how to use the saw.

•

When feeding the work-piece into the machine, do so at a rate where cutting is efficient and there is not
unnecessary force on the blade that can cause deflection and breakage.

•

The blade teeth cut on the down stroke ONLY.

•

Best results are achieved when cutting materials under 25mm (1") thick. When cutting material thicker
than 25mm, feed the work-piece very slowly into the blade and take extra care not to bend or twist the
blade while cutting.

•

Teeth on scroll saw blades wear out and the blades must be replaced for best cutting results. Blades
generally stay sharp for 1/2 hour to 2 hours of cutting.

•

To get accurate cuts, be prepared to compensate for the blade tendency to follow the wood grain.

•

This scroll saw is primarily designed to cut wood or wood products. For cutting precious and nonferrous
metals, the speed control must be set to very slow speeds.

•

When choosing a blade, use very fine, narrow blades to cut materials 6mm (1/4") thick or less. Use wider
blades for thicker materials. Wider blades, however, reduce the ability to cut tight curves.

•

Blades wear down faster when cutting plywood or abrasive particle board. Angle cutting in hardwoods
also wears blades down faster.