Baumr-AG HD2, Руководство пользователя

Страница: 9 / 10

20V Cordless Hammer Drill / Driver HD2
E&OE © 2017 Bäumr-AG 9
Maintenance and Troubleshooting
Remove
the battery from the tool before performing any maintenance. • The machine should
be cool enough to touch before performing maintenance activities. • Some maintenance
activities described may be beyond the scope of some users. For procedures that you are not comfortable
with or have the tools or experience for, have the unit serviced by a service centre or qualified technician.
•
Clean the tool regularly with a soft cloth
– do NOT use water, solvents, abrasives etc. Remove any
debris from the chuck and tool ventilation slots using a soft brush.
The following information may assist in identifying a problem and rectifying it.
Drill will not operate.
Possible Fault Action
No voltage Ensure the battery is charged and is correctly inserted.
Direction not correctly selected Ensure that the direction selector is properly set.
Drilling / Screwing is poor.
Possible Fault Action
Low voltage Ensure the battery is charged .
Bit dull or damaged Sharpen or replace drill bit.
Material too hard, cutting speed or
mode incorrect
Use correct drill bit for the material and operating mode. Adjust speed to suit drill diameter
and material hardness. For hammer drilling, use "hammer" mode and high speed.
Incorrect torque Adjust torque to suit screw diameter and material.
Excessive vibration.
Possible Fault Action
Bit dull, bent or damaged Sharpen or replace drill bit.
Specifications
Battery Charger Electrical Requirements 240VAC / 50Hz
Battery Type 20V Lithium-Ion
Drilling Speed 0 to 350 RPM
– Speed 1 / 0 to 1300 RPM – Speed 2
Chuck Capacity 10mm