20V Cordless Hammer Drill / Driver HD2
E&OE
© 2017 Bäumr-AG
7
Operation
Changing Bits
1.
Remove the battery from the tool or place the
forward/reverse selector in the centre "trigger
lock" position.
2.
Hold the tool body firmly with one hand.
3.
Rotate the outer ring of the chuck (
A
) left (anti-
clockwise) to open the chuck jaws.
4.
Insert the bit into the chuck.
5.
Rotate the outer ring of the chuck right (clockwise) to close the chuck jaws until the bit is
firmly clamped.
Selecting Speed Range and Controlling Speed
Actual speed is controlled by how much you pull the trigger. Pulling the trigger in fully will apply the
highest speed available for the currently selected range.
• Do NOT change the speed selector while
the tool is running.
•
Slide the speed selector switch (
B
) forward to select the lower
speed range (0 to 350 RPM). "
1
" can be seen on the speed
selector switch.
•
Slide the speed selector switch (
B
) backward to select the
upper speed range (0 to 1300 RPM). "
2
" can be seen on the
speed selector switch.
Selecting Direction
When the forward / reverse selector (
C
) is in the middle position, the trigger is "locked". • The image
shows the tool in "forward" mode
. • Do NOT change direction while the tool is running.
The chuck can rotate "forward" (right or clockwise) for drilling and for
screwing in / tightening. Similarly, the direction of rotation can be
"reverse" (left or anti-clockwise) for screwing out / loosening.
•
To rotate forward, push the forward / reverse selector (
C
) in fully
from the right-side of the tool.
•
To rotate in reverse, push the forward / reverse selector (
C
) in fully
from the left-side of the tool.
A
B
C
