Bedienungsanleitung_Series09-US_RS232_V1_e.doc
6/11
Baumer Electric AG
26.03.2013 14:43:00/tof
Frauenfeld, Switzerland
Configuration
Load factory
settings
D
{0D}
{0Dßß}
The Sensor is configured with its
factory settings.
See chapter „Factory
configurations“
Set measuring
mode
A
{0AX}
{0AXßß}
X
A: absolute measurement in 0.1mm
steps
B: relative measurement within the
Teach-range 0…4096
See chapter „Commands explained
in detail“
Set output
format of
permanent
periodical data
output
F
{0FX}
{0FXßß}
X
A: ASCII
B: Binary
See chapter „Commands explained
in detail“
Set sensor
sensitivity
(Sensors with
beam
columnator)
B
{0BX}
{0BXßß}
X
A: Highest sensitivity
Measuring into test tubes
Measuring range: 3…150 mm
B: Second highest sensitivity
Measuring into plates size 96 with
big hole diameter
Measuring range: 3…110 mm
C: Second lowest sensitivity
Measuring into plates size 96 with
small hole diameter
Measuring range: 3…70 mm
D: Lowest sensitivity
Measuring into plates size 384
Measuring range 3…30 mm
See chapter „Commands explained
in detail“
Set number of
averagings
C
{0CX}
{0CXßß}
X
A: not averaged
B: 2
C: 4
D: 8
E: 16
F: 32
G: 64
See chapter „Commands explained
in detail“
Temperature
compensation
on, off
G
{0Gx}
{0Gxßß}
x
0: Temperature compensation off
1: Temperature compensation on
See chapter „Commands explained
in detail“
Teach-in of Sdc X
{0X}
{0XXßß}
X
Reads and stores close limit Sdc
A: Teach-in successful
B: No object within measuring
range
→
basic setting for the
sensitivity the currently set
sensitivity level
