Baumatic PHC620SS, Инструкция по эксплуатации

Страница: 27 / 32

Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement.
The mains supply cable should be replaced in accordance with the
following instructions:
o
Switch the appliance off at the control switch.
o
Open the terminal block on the underside of the hob.
o
Unscrew the terminal screws fixing the cable.
o
Replace the cable with one of the same length and in accordance
with the specification given on page 25.
o
The “green-yellow” earth wire must be connected to the terminal
marked
. It must be about 10 mm longer than the live and
neutral wires.
o
The “blue” neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).
My appliance isn’t working correctly
o
The cooking zones are not functioning or will not switch
on.
*
It has been more than 10 seconds since the appliance was
switched on. You should switch the appliance on again, using the
ON/OFF button.
*
The safety lock has been switched on (see the “Locking the hob
top” section for information on how to turn off the safety lock).
*
Several cooking zone selection buttons have been pressed at
once. You should only touch one cooking zone selection button at
once.
*
The safety cut out has been triggered. Press the ON/OFF button
(1) to reset the appliance.
*
Check that the mains electrical supply to the appliance is correct
and working. Check the mains fuse.
27