Baumatic BWM50, Инструкция по эксплуатации

Страница: 30 / 36

30
o
The moulded plug that is supplied with the appliance must be
placed into an earthed and insulated socket.
o
Broken or damaged power leads must only be replaced by a
suitably qualified person. A power lead of a similar type must be
used in replacement.
o
IMPORTANT: We do not recommend that this appliance is
connected to an extension lead.
Before first use maintenance wash
o
When your washing machine has been correctly installed, we
recommend that you perform a maintenance wash cycle, without
any clothing being placed inside of the drum.
o
This will check that all aspects of the installation are correct; it will
also remove any deposits that may have been left on the drum by
the manufacturing process.
o
Select the NORMAL program (see the “Setting a wash program”
section).
Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear on the LED display.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR
POWER SUPPLY.
Error
code
Problem Reason Solution
E1 Water not
draining.
o
Drainage pipe is kinked or
blocked so the water
cannot be drained.
o
The drain pipe is located
above 90 cm from the
ground.
o
Open the lid
after the drum
has stopped
spinning and
check the
drainage pipe.
E2 Machine isn’t
spinning.
o
The lid is not closed
properly during the cycle.
o
Ensure the lid
is properly
closed.
E3 Excessive noise
during spin.
o
The laundry is not
distributed evenly in the
drum, so the load is
colliding with the drum
wall creating noise.
o
The machine
will try to
correct the
load twice
before omitting
a warning.