5
A3
Installing the gas-supply coupling
These instructions are for authorised cook top installers in accordance with standards AS 5601. Any procedure
must be carried out with the appliance disconnected from the electricity mains.
ATTENTION:
the packaging contains two couplings, one cylindrical and one conical; choose the conical coupling
for installation.
CYLINDRICAL CONICAL
Installation sequence:
Fasten the swivel coupling to the gas inlet pipe of the cook top (which has a cylindrical male gas-thread) inserting
the seal.
-
Tighten the coupling, remembering to point it in the required direction.
-
Connect the cook top to the gas mains by fitting the seal and fastening the mains pipe to the swivel coupling.
A1
= Inlet pipe
A2
= Seal
A3
= Swivel coupling
Only use pipes and seals that comply with AS5601. These pipes must be installed so that, when fully extended,
their length does not exceed 2000 mm. To facilitate installation and to prevent gas leaks, firstly attach the swivel
coupling to the cook top and then to the gas mains pipe. Inverting this sequence may hamper the gas seal between
the pipe and the cook top.
Important: when installation is complete, check that all the couplings are completely sealed by using a
soapy solution. Never use a flame. Also ensure that the flexible pipe cannot come into contact with any
moving part of the cook top (e.g. drawer) and that it is not in a position where it could be damaged.
A1
A2
