4
2. Electric connections
Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated
mains voltage and power available are suitable for its operation.
Before making the electric connections, check the efficiency of the earthing system. Earthing of the cook top is
compulsory by law. The manufacturer will accept no liability for any personal injury or damage to property deriving
from failure to comply with this requirement.
Use only rubber cable type H05RR-F; the cross-section of the wires must be 3x1.5 mm.
DECLARATION OF CONFORMITY. In the parts destined to come into contact with foodstuffs, this appliance is in
accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of
25/01/92.
CE
Appliance conforming to the European directives 90/396/CEE, 89/336/EEC, 93/68/EEC, 73/23/EEC and
subsequent revisions.
Connection options
CONNECTION (GAS PART)
The gas supply must be connected by use of the ½ BSP Elbow, Seal, Regulator supplied (Natural Gas only) or
Test Point Assembly supplied (LPG only) and copper pipe or flexible hose connection. An isolation tap fitted in an
easily accessible position is recommended.
The nameplates on the gas cook tops state the type of gas to be used with the appliance.
However other types of gas can be used after making a few minor modifications.
(See the Instructions in Section titled ‘Adaptation to different Gas types’ on page 5.)
Gas-supply connection
The cook top must be connected to the gas mains or canister in accordance with Standards AS 5601, ensuring
beforehand that it is regulated to suit the gas-supply. If it is not, follow the instructions in the “Adapting to different
gas types” paragraph. If fed by a canister of liquid gas, use pressure regulators that are AGA Certified.
Important: for safe operation, suitable use of energy and longer equipment life, ensure that the feeding pressure is
within the values shown in the table (Burner Technical Details page 6 and the data label).
Flexible Hose Assembly
The appliance is suitable for connection with an AGA Approved, Class B or D Flexible Hose Assembly, which
complies with AS/ANZ1869 and is 1200mm maximum length and 10mm minimum internal diameter. Ensure that
the Hose does not contact the hot surfaces of the hotplate, oven, dishwasher or other appliance that may be
installed underneath or next to the hotplate. The hose should not be subjected to abrasion, kinking or permanent
deformation and should be able to be inspected along its entire length. Unions compatible with the hose fittings
must be used and connections tested for gas leaks. The supply connection point shall be accessible with the
appliance installed.
