INSTALLATION
TECHNICAL INFORMATION FOR THE
INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
The appliance must be correctly installed in
conformity with current law and the
manufacturer's instructions.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or by
his duly authorized dealer.
3) INSTALLING THE HO
B
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children’s reach since they could become
potential sources of danger.
The measurements of the opening made in the
top
of
the
modular
cabinet
and
into
which
the
ho
b
will
be
installed
are
indicated
in
either
fig.
7.
Always
comply
with
the
measurements
given
for
the
hole
into
which
the
appliance
will
be
recessed
(see
fig.
7
and
8).
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
4) FIXING THE HO
B
The ho
b
has a special seal which prevents
liquid
from getting into the cabinet. Strictly comply
with
the following instructions in order to correctly
apply this seal:
-
Detach
the
seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
-
Overturn the ho
b
and correctly position seal
“E” (fig. 9) under the edge of the ho
b
itself, so
that
the
outer
side
of
the
seal
perfectly
matches
the
outer
edge
of
the
ho
b
.
The
ends
of
the
strips
must
fit
together
without
overlapping.
-
Evenly and securely fix the seal to the ho
b
,
pressing into place with the fingers and remove
the
strip
of
protective
paper
from
the
seal
and
set
the
hob
into
the
hole
made
in
the
cabinet.
- Fix the hob with the proper brackets “S” and fit the
prominent part into the porthole “H” on the bottom;
turn the screw “F” until the bracket “S” stick on the
top (fig. 10).
IMPORTANT: When not installing above an
oven, underneath the appliance there must be a
partition made of insulating material (e.g. wood).
There must be a gap of at least 70 mm between
the underneath of the appliance and this partition
(fig. 7.).
FIG. 7
FIG. 8
FIG. 9
FIG. 10
COMPLY WITH THE DIMENSIONS
(mm)
6
IMPORTANT:
A
perfect
installation,
adjustment or transformation of the
gas hob
to
use
other
gases
requires
a
QUALIFIED
GASSAFE
INSTALLER:
a
failure
to
follow
this
rule
will
void the warranty.
A B C D
E
4F (60)
553 473 63.5 63.5 100 min.
5F (70)
553 473 63.5 63.5 175 min.
5F (90)
833 475 62.5 62.5 73.5 min.
Содержание BHG900.6SS
