Baumatic BHG690SS-ANZ, Инструкция по эксплуатации

Страница: 20 / 32

20
o
Place the clamp (B) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw (C) through the clamp (B) so that
the clamp is attached to the hob, but so that you can still adjust
the position of it.
o
Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o
On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. Then fully tighten the screws
(C) to secure the hob into position.
Gas connection
This appliance must be installed by a competent
person in accordance with the current standards.
Important information
o
This hob is supplied to run on natural gas only and cannot be
used on any other type of gas without modification.
o
A regulator is required but not supplied with the Cooktop (NZ)
o
Conversion for use on LPG and other gases must only be
undertaken by a qualified person. For information on the use of
other gases, please contact the Customer Care department.
o
The hob must be installed by a qualified person, in accordance
with the current edition of the Gas Safety and Measurement
Regulations 2010 and the relevant building Regulations.
o
Failure to install the appliance correctly could invalidate
Baumatic’s guarantee and lead to prosecution under the
regulations quoted above.