Baumatic BDWS45SS, Инструкция по эксплуатации

Страница: 30 / 48

IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT
THE CUSTOMER CARE DEPARTMENT ON TELEPHONE
NUMBER (0118) 933 6911.
30
ALL.
IF AN ENGINEER ATTENDS DURING THE GUARANTEE
PERIOD AND FINDS THAT A FAULT HAS BEEN
CAUSED BY AN ITEM ON THE ERROR CODE LIST,
WHICH COULD HAVE BEEN CLEARED BY THE
CUSTOMER. THEN YOU MAY BE LIABLE FOR THE
COST OF THE SERVICE C
General troubleshooting
PROBLEM POSSIBLE
CAUSES
WHAT TO DO
Dishwasher
doesn’t
run
Fuse blown or the
circuit breaker has
tripped
Power supply is not
switched on
Water pressure is
low
Replace the fuse or reset the circuit
breaker. Remove any other
appliances that are sharing the same
circuit with the dishwasher.
Make sure that the dishwasher is
turned on and that the door is closed
securely.
Make sure that the power cord is
fully plugged into the wall socket.
Check that the water supply is
connected properly and that the
water is turned on.
Drain pump
doesn’t stop Overflow The system is designed to detect an
overflow. If it does, then it will run
the drain pump continuously when
there is power to the appliance.
Noise Some audible sounds
are normal
Utensils are not
secure in the baskets
or something small
has dropped into the
basket
You will get a level of operating noise
during a wash cycle, in particular
when food is being removed from
items and when the detergent
dispenser places the tablet into the
tub.
Ensure that everything is loaded as
per Baumatic’s loading instructions.