CLEANING AND MAINTENANCE
Important:
do not use water pressure cleaners or steam cleaners.
Exterior of the oven
Clean with a damp cloth. If it is very dirty, add a few drops
of washing up detergent to the water. Wipe with a dry cloth.
Do not use corrosive or abrasive detergents, which dull the
surface. In the event that one of these products comes into
contact with the oven, immediately clean it using a damp cloth.
Slight differences in colour on the front of the appliance are
determined by the different materials used, such as glass, plastic
and metal.
Accessories
Soak the accessories in water with washing up detergent imme-
diately after use. Food residues can be easily removed using a
brush or sponge.
Oven cavity
Do not use abrasive cleaners or pan scourers. Use special oven
cleaners and follow the manufacturer's instructions.
After every use, wait for the oven to cool then clean it to prevent
the build-up of baked-on food residues.
With long cooking times or when cooking on different levels,
especially food with a high water content (pizzas, stuffed vege-
tables, etc.), condensation may form on the inside of the doors
and the seal. When the ovens are cool, dry the inside of the doors
with a cloth or sponge.
Clean the glass of the doors with a suitable liquid detergent.
Replacing the bulb
Warning:
Disconnect the appliance from the power supply.
To remove the side runner frame, push it simultaneously down
and towards the centre of the oven (A-fig.1). Then lift the side
runner frame upwards to release it from the cavity wall (B-fig.1).
Prise off the glass cover C using a screwdriver E.
Change the lamp D (fig.2). Refit the glass cover, pressing it
slightly (fig.2). To refit the side runner frame, follow the steps
above in reverse order.
Removing the oven doors (for cleaning)
To facilitate cleaning, the oven door can be removed as follows:
hinges F are provided with two movable bolts G. When bolt G
is raised, the hinge is released from its housing. Having done this, the door must be lifted
upwards and removed, sliding it outwards; hold the sides of the door near the hinges when
performing these operations.
To refit the door, insert the hinges into their seats and open the door fully. Remember to
rotate the two movable bolts G used to hook the two hinges before closing the door (fig. 3).
WARNING: take care not to dislodge the hinge lock system when removing the door
as the hinge mechanism has a strong spring system! Do not immerse the door in water
at any time.
Fig. 1
Fig. 3
Fig. 2
21