16
.
appliance
gainst the aperture. This will make it difficult to remove the hob from
d then gently lower it into the
rneath of the hob, place the
clamp(s) (B) into position on in each corner
of the hob.
a position that is
suitable for your worktop, as shown in the
diagrams on the left.
crew (C) through each
clamp (B) so that the clamp is
attached to the hob.
hob, you can fully tighten the screws (C) to
osition.
o
Remove the protective covering from the sealing strip
o
Apply the sealing strip provided around the edge of the appliance
o
Do not leave a gap in the sealing strip or overlap the thickness.
IMPORTANT: Do not use a silicon sealant to seal the
a
the aperture in future, particularly if it needs to be serviced.
o
Carefully turn the hob back over an
aperture hole that you have cut out.
o
On the unde
o
Adjust the clamps into
o
Slightly tighten the s
o
Once you are satisfied of the position of the
secure the hob into p
