26
o
Carefully turn the hob upside down and place it on a cushioned
mat.
o
Apply the sealing strip (A) provided around the edge of the
appliance.
o
The protective covering must be removed from both sides.
o
Do not leave a gap in the sealing agent or overlap the thickness.
o
IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future if it needs to be serviced.
(A) Sealing strip
(B) Clamp
(C) Screw
o
Place the clamp (B) over the holes that match the size of the
screws. There are one set of screw holes in each corner of the
hob. Slightly tighten a screw (C) through the clamp (B) so that
the clamp is attached to the hob, but so that you can still adjust
the position of it.
o
Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
