Bauknecht IR6 EP8VS2 PT, Инструкция по безопасности, эксплуатации и установке

Страница: 5 / 36

EN
5
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3 mm is required
and the appliance must be
earthed .
If the power cable is damaged,
replace with an identical one .
The power cable must only be
replaced by a qualified
technician in compliance with
the manufacturer instruction
and current safety regulations .
Contact an authorized service
center .
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by
means of an accessible multi-
pole switch installed upstream
of the socket in conformity with
national electrical safety
standards .
The rating plate is on the front
edge of the oven (visible when
the door is open) .
In case of replacement of power
cable, contact an authorized
service center .
If the fitted plug is not suitable
for your socket outlet, contact a
qualified technician .
The power cable must be long
enough to connect the
appliance, once fitted in its
housing, to the main power
supply . Do not pull the power
supply cable .
Do not use extension leads,
multiple sockets or adapters .
Do not operate this appliance if
it has a damaged mains cord or
plug, if it is not working
properly, or if it has been
damaged or dropped . Keep the
cord away from hot surfaces .
The electrical components must
not be accessible to the user
after installation .
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot .
CLEANING AND
MAINTENANCE
Never use steam cleaning
equipment .
WARNING:
Ensure that the
appliance is switched off before
replacing the lamp to avoid the
possibility of electric shock .
Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the appliance door glass
since they can scratch the
surface, which may result in
shattering of the glass .
Remove all accessories before
running the pyrolytic function
(also the lateral grids) .
Wear protective gloves for
cleaning and maintenance .
The appliance must be
disconnected from the power
supply before any maintenance
operation .
Ensure the appliance is cooled
down before carrying out any
cleaning or maintenance
operation .
If the oven is installed below a
hob, make sure that all burners
or electric hotplates are
switched off during the
selfcleaning (pyrolytic) function .