BAUKER PSR850G2, Оригинальное руководство пользователя

Страница: 13 / 16

EN-13
METAL CUTTING
This saw has different metal cutting capacities depending upon the type of blade being used
and metal being cut.
Use a finer blade for ferrous metals and a coarse blade for non-ferrous metals.
When cutting thin gauge sheet metals, ALWAYS clamp wood on both sides of the sheet.
This will give you a clean cut without excess vibration or tearing of the metal.
DO NOT force the cutting blade. Forcing the blade will reduce blade life and cause the blade
to break.
NOTE: We recommend that you spread a thin film of oil or other coolant along the line
of cut ahead of the saw. This will allow easier operation and help extend blade life. When
cutting aluminum, use kerosene.
WORK HINTS FOR YOUR RECIPROCATING SAW
If your power tool becomes too hot, set the speed to maximum and run a no load for 2-3
minutes to cool the motor.
Always ensure the work-piece is firmly held or clamped to prevent movement.
The blade guard must be held firmly against the material being cut to reduce saw vibration,
blade jumping and blade breakage.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.