BAUKER PSR850G2, Оригинальное руководство пользователя

Страница: 12 / 16

EN-12
position of the surface. It must be held firmly against the material being cut to reduce saw
vibration, blade jumping and blade breakage. (See Fig. B1)
If you need to reduce the cutting capacity of your tool (depth of cut), the pivoting blade foot
(2) may be adjusted as follows. Rotate the shank (8) on the underside of the front housing
forwards. Slide the pivoting blade foot (2) to the required position. Rotate the grip back and
check that the blade foot (2) is firmly latched. (See Fig. B2)
2. CONTROLING THE STROKE RATE
For sawing appropriately to the material a suitable stroke rate can be set with the regulating
wheel and controlled with the switch.
3. CUTTING INSTRUCTION
PLUNGE CUTTING (See Fig. C1, C2)
Warning: The plunge cutting procedure is only suitable for treating
soft materials such as wood, plaster board or similar! Do not work
metal materials with the plunge cutting procedure!
Use only short saw blades for plunge cutting.
Place the machine with the edge of the pivoting blade foot (2) onto the workpiece and switch
on. For power tools with stroke speed control, set the maximum stroke speed. Press the
power tool firmly against the workpiece and allow the saw blade to slowly plunge into the
workpiece.
As soon as the pivoting blade foot (2) fully lays on the surface of the workpiece, continue
sawing alongside the desired cutting line. For certain work, the saw blade (1) can also be
inserted turned through by 180° and the sabre saw can be guided accordingly in a reversed
manner.
Flush cutting (See Fig. D1, D2)
Warning: Pay attention that the saw blade always extends beyond the
diameter of the material being worked.
There is danger of kickback.
It is possible to make cuts extremely close to floors, walls and other difficult areas. Insert the
blade shank into the blade clamp with the blade teeth facing up (opposite to normal working
position). This will make cuts closer to the work surface. Using special flexible blades insert
the blade into the blade clamp with the blade teeth facing down (normal working position). It
will allow flush pipe cutting.
WOOD CUTTING
For easier control use low speed to start cutting, then increase to the correct speed.