BAUKER PGA125G2, Оригинальное руководство пользователя

Страница: 16 / 20

EN-16
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for cutting, roughing and brushing metal and stone materials without using
water. For cutting metal, a special protection guard for cutting (not supplied) must be used.
1.INSTALLING AND ADJUSTING THE WHEEL GUARD (GRINDING OR CUTTING)
Before any work on the machine itself, pull the mains plug.
For work with grinding or cutting discs, the wheel guard must be mounted.
Wheel Guard for Grinding
Open the clamping lever (8). Place the wheel guard (5) with coded projection into the coded groove on
the spindle of the tool head and rotate to the required position (working position). (See Fig. A1)
To fasten the wheel guard (5), close the clamping lever (8). (See Fig. A2)
The closed side of the wheel guard (5) must always point to the operator.
NOTE:
With the clamping lever (8) open the clamp adjusting nut (12) can be adjusted to ensure the
guard is securely clamped after the clamping lever (8) is finally closed.
WARNING:
For cutting metal, always work with the wheel guard for cutting. The coded projection on
the wheel guard (5) ensures that only a guard that fits the tool type can be mounted.
Wheel Guard for Cutting (available for helpline)
The wheel guard for cutting is mounted in the same manner as the wheel guard for grinding.
2. INSTALLING AND ADJUSTING AUXILIARY HANDLE (SEE FIG. B)
You have the option of two working positions to provide the safest and most
comfortable control of your angle grinder. The handle is screwed clockwise into
either hole on the sides of the gear case.
NOTE:
This handle should be used at all times to maintain complete control of the tool.
3. FITTING THE DISCS (SEE FIG. C1-C3)
Put the inner flange onto the tool spindle. Ensure it is located on the two flats of spindle (See Fig. C1).
Place the disc on the tool spindle and inner flange. Ensure it is correctly located. Fit the threaded outer
flange making sure it is facing in the correct direction for the type of disc fitted. For grinding discs, the
flange is fitted with the raised portion facing towards the disc. For cutting discs, the flange is fitted with
the raised portion facing away from the disc (See Fig. C2).
Press in the spindle lock button (9) and rotate the spindle by hand until it is locked. Keeping the lock
button pressed in, tighten the outer flange with the spanner provided. (See Fig. C3)
NOTE:
After mounting the grinder tool and before switch on, check that the grinding tool is correctly
mounted and that it can be turn freely, make sure that the grinding tool does not graze against the
protecting guard or other parts.
4. SPINDLE LOCK BUTTON(SEE FIG. D)
Clean the grinder spindle and all parts to be mounted. For clamping and loosening the grinding tools,
lock the grinder spindle with the spindle lock button.
WARNING:
Actuate the spindle lock button only when the grinder spindle is at a standstill!
5. HAND GRIP AREAS
Always hold your angle grinder firmly with both hands when operating.