40
39
Using instructions
of the impact drill
Before operating
the impact drill
Slip to the right if you want to strike in concrete
(striker) of to the left if you want to strike wood
or metal.
Always be sure you have a firm footing. Put the driller over a surface before plug into an
inlet.
1. Store the mandrel key attached to the tool or in the box.
2. Connect the key in one of the three holes of the mandrel. Turn anticlockwise to open
the clamps of the mandrel. These clamps keep the drill bit centered.
3. Put the drill bit between the open clamps until stop in the bottom of the mandrel.
4. Hold the back of the mandrel firmly. Close the clamps until these assure firmly the
drill bit. Assure with a squeeze turning the key clockwise.
5. Once the mandrel and the drill bit are prepared, check that the switch is in the OFF
position and in the rotating side to right. After that you can plug the driller to the inlet
and operate.
Striker / Driller
NEVER:
use the rotating inverter neither the striker switch with the driller running
since it may cause the gears breaks with the high speed of the tool. Wait until the
mandrel completely stops to realize the wished change.
ENVIRONMENTAL PROTECTION
Information for the environmentally responsible disposal of electrical and electronic
equipment waste (WEEE), for private users.
This symbol on the products or accompanying documents means
that used electrical and electronic equipment should not be disposed
of with general household waste.
For proper disposal, treatment, recovery and recycling, take these
products to the designated collection points, where they will be
accepted free of charge. Alternatively, in some countries, you may be
able to return your products to your local retailer upon purchase of
an equivalent new product. Disposing this product correctly will help to save valuable
resources and prevent any potential negative effects on human health and the
environment, which could otherwise arise from inappropriate waste handling and
disposal. Please contact your local authorities for further details on your nearest
designated collection point. Penalties may apply for the incorrect disposal of these
wastes, in accordance with your local legislation.
If you wish to discard electrical and electronic equipment, please contact your local
authorities or your retailer for information on the correct disposal method.
SYMBOLS
The data plate of your product may contain some symbols. They represent important
information about the product or instructions for use.
Wear hearing protection
Wear eye protection
Wear respiratory protection
In compliance with safety standards
Read the instruction manual
The product is in compliance with RoHs
General warning
Electrical items and electronic devices should not be disposed of with household waste.
Recycle them in the corresponding facilities.
Contact your local authorities or distributor for information on recycling.
