38
37
Using instructions
of the impact drill
Assure that the maintenance and repair of your power tool by a qualified repair person
using only identical replacement parts. This will ensure that the safety of the power tool
is maintained.
Service
- Make sure to connect the tool to a safe electric net, with the same voltage indicated in
the specification brand of the product.
- Always verify that the installed drill bit is well connected to the mandrel, for that use
the provided mandrel key to give the required pressure.
- Always work with the adequate safety implements (gloves, goggles, shoes, helmet and
relevant clothing). Remember that to work in metal, it produces sparks that may provoke
burns.
- Avoid work with flammable material in closeness.
- Do not press to much the drill bit over the surface and do not push lateral loads.
- Keep close a fire extinguisher; remember that the sparks may cause fire.
- To change drill bits, is recommended that disconnect the tool from the inlet avoiding
unexpected starts, causing injuries.
If you need use a cord extension, use an adequate extension, accord to the length of it.
- Less than 5 meters, it must be of 0.75 mm
2
section. Over 5 meters, use a certified
extension of 1.0 mm
2
section. Avoid low voltages that may provoke overheating of the
tool.
Specific rules for Blower
Using instructions
of the impact drill
Before unpacking the driller, verify that account with all its parts and pieces: Driller,
Mandrel Key, replacement coal kit. If any of it is missing, go immediately with the entire
product and purchase receipt where it was originally bought.
Installation and start up
Turn the handle to select the rotating side, indicates Right and Left.
Turn the knob to increase or decrease
the maximum rotating speed
Rotating inverter
Speed controller
