52
51
With this system, just press the sandpaper into the base to install it
and pull it to remove it.
Fixing
Align the sandpaper with the base correctly before fixing it, in order
to ensure an efficient dust extraction and a satisfactory result.
Gently press the sandpaper to secure it into the base (fig. 4).
Grab the sandpaper from one of its corners to remove it from the base (fig. 5).
Install a new sandpaper piece.
Fastening system with Velcro
Removing/replacement
¡WARNING!
Sempre desligue e desconecte a ferramenta antes de realizar qualquer ajuste.
1. Loosen the 4 screws (15) with a Phillips screwdriver. Then, remove them together with the
pre-installed sandpaper base (14a) (Fig. 1).
2. Reinstall/adjust the counter flange (11) and disc (10), if necessary.
Align the pins (11a) with the holes (10a) and fit the counter-flange (11) into the disc (10) (Fig. 2). Make
sure the pins are correctly fitted into the holes.
3. Make sure the counter flange (11) and disc (10), are in the correct position.
Select the required base (14c) for the operation to be performed.
4. Align the holes and fit the base disc (14c) into the counter-flange (11)/disc (10). Then, fix the base
disc (14c) with the 4 screws (15) (Fig. 3).
Interchangeable bases
Change of the base
Illustration
Uso
For general sanding work
in areas of moderate size
To quickly smooth flat and
large surfaces, to prevent
marks or scratches
Nome
Base for sandpaper
Base disc for orbital
sander
Operation Instructions
12
14a
Fig 1
11a
11
10
11a
Fig 2
14 c
Fig 3
14c
16c
14a
16a
Fig 4
14a
16a
14c
16c
2.
2.
1.
1.
Fig 5
