Page 9
For technical questions, please call 1-888-866-5797.
Item 64483
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Work area Set up
1. Verify that work area has adequate
lighting for the job.
2. Make sure work area is free of flammable liquids,
vapors or dust that may ignite. Sparks can be
generated during Drain Cleaner operation.
Do not work in area until these sources of
ignition have been identified and corrected.
3. Do not use the appliance while standing in water.
If needed, remove the water from the work area.
4. Inspect the drain to be cleaned. If possible,
determine the best access point(s) to the drain, the
size(s) and length(s) of the drain, distance to tanks
or mainlines, the nature of the blockage, presence
of drain cleaning chemicals or other chemicals, etc.
5. If there are chemicals present in the drain, read
and adhere to the specific safety measures
required to work around those chemicals.
Contact the chemical manufacturer for required
safety instructions and information.
6. If necessary, remove fixture (toilet, sink, etc.) to
allow access to the drain.
Do not feed the cable
through a fixture.
This could damage
the Drain Cleaner and the fixture.
7. If needed, place protective covers over
the work area floor. Cleaning the clogged
drain can be a messy operation.
8. To prevent Cable from whipping, place
Drain Cleaner within 6 inches of drain line.
the greater the distance from the drain line, the
higher the risk of the cable twisting or kinking.
9. If needed, set up barriers to keep
bystanders away from the Drain Cleaner
and work area during operation.
