Page 14
For technical questions, please call 1-888-866-5797.
Item 58162
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Troubleshooting
problem
possible causes
Likely Solutions
Tool will not start. 1. Battery discharged.
2. Internal damage or wear.
(Carbon brushes or
switch, for example.)
1. Charge Battery.
2. Have technician service tool.
Performance
decreases
over time.
1. Accessory dull
or damaged.
2. Carbon brushes
worn or damaged.
1. Keep cutting accessories
sharp. Replace as needed.
2. Have qualified technician replace brushes.
Excessive noise
or rattling.
Internal damage or wear.
(Carbon brushes or
bearings, for example.)
Have technician service tool.
Overheating.
1. Forcing tool to
work too fast.
2. Accessory dull
or damaged.
3. Blocked motor
housing vents.
1. Allow tool to work at its own rate.
2. Keep cutting accessories
sharp. Replace as needed.
3. Wear ANSI-approved safety goggles
and NIOSH-approved dust mask/
respirator while blowing dust out of
motor using compressed air.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
pLEASE READ THE FOLLOWING cAREFULLy
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
