Saturno Max - Saturno Max/S
3
2005
1.
Open the box containing SATURNO MAX from the upper side marked as ALTO ,
take instructions manual and read carefully.
2.
It is recommended to lay the machine flat and in such a position so as to allow a
smooth operation and a perfect maintenance.
4.
CONNECTION AND STARTING
1.
Connect the rubber tube to WATER INLET hose holder that is placed on SATURNO
MAX (fig. 1-3), turn the water tap and connect the boiler discharge pipe. N.B.: use
only normal tap water coming from water supply for domestic use. Never add
additives to water.
IN CASE OF CONNECTION WITH WATER TANK: Connect the SATURNO MAX to a tank
for condensate recovery (fig. 5). N.B.: the temperature of water in the tank must
never go over 40° C; if it happens, the tank must be equipped with an automatic
temperature control device for water discharge and cold water input;
2.
connect the power supply cable to a protected outlet with earth protector switch,
with observance of the law in force and a voltage suitable to SATURNO MAX;
3.
connect the pipes of the plant to the machine and make sure that they are well
covered in order to avoid possible burns;
4.
turn on the main switch and the switches for heating element 1 and 2 (fig. 2), turn
the sluice valve which takes steam to the plant (fig. 1). Wait for lamps 1 and 2 to
switch off; now, the manometer should mark a pressure of 4,5 BAR.
5.
POSSIBLE PROBLEMS AFTER INSTALLATION
The pump lamp is on and the pump is working, but the machine gets no water:
-
Make sure the water tap is open.
-
Make sure the aqueduct is supplying water. For the machines connected
to a water tank, check if there is water in the tank (fig. 5).
WATER INLET
WATER
DISCHARGE
STEAM DELIVERY
Fig. 3
