Battipav VIP 845, Руководство по эксплуатации

Страница: 15 / 15

23
Battipav srl GB
DISPOSAL
When parts wear out or when the machine is finally
scrapped, waste disposal must be carried out in
compliance with the laws in force.
Electric Motor
Aluminium AL
Steel AC
Copper CU
Polyamide PA
Main Body
Steel AC
Polyamide PA
Submersed pump
Polyamide PA
Steel AC
Aluminium AL
Copper CU
Epoxy Resin
W.E.E.E. IT08020000002803
The European Directive 2002/96/CE
arranges that in the event of scrapping
of electrical equipment, they must not
be disposed of city solid refusals but collected
separately, in order to optimize the level of recovery
and recycling of the materials and above all in order
to prevent damages to health and environment.
To comply with European Directive 2002/96/CE, all
electrical equipments must be marked with crossed
basket symbol.
The packing of the machine will be disposed of in
accordance with the methods laid down by current
legislation.
For further information concerning disposal
of electrical equipment, please refer to public
administration service.
TROUBLESHOOTING
haVe your tooL rePaired By a QuaLiFied PerSoN
this electric tool complies with the relevant safety rules. repairs should only be carried out by qualified
persons using original spare parts, otherwise this may result in considerable danger to the user.
Faul Cause Remedy
The machine does not work. The power supply cable is damaged or
not properly connected.
Press the plug firmly into the power
socket. Check the power supply cable.
No voltage in the socket. Have the socket checked.
Control switch is damaged. Consult local dealer for replacement.
If lubrication does not arrive at the
disk with the pump running.
The sprayer unit is clogged. Dismantle the sprayer assembled inside
the disk cover and remove any possible
residuals.
Motor gives off unpleasant odour. Water may have seeped through inside
the motor
Unplug the power supply cable and
consult local dealer.
Machine is difficult to start. Motor bearings are damaged. Unplug the power supply cable and
consult local dealer.
The machine is cutting out of square. The tile supports are not at right angles
with the cutting disc.
Using a square, adjust the tile supports
to 90° in relation to the cutting line of
the disc.
The disc is not suitable for the type of
material to be cut.
Replace the disc with a more suitable
one.