Rev. A-021210
Page 17
P/N VDC E12248-S2-MNL
BatteryMINDer
®
E12248-AA-S2
Correct polarity and a good connection will be your reward.
Attach the
BCA
to the proper battery posts, clamps or screw
terminals, depending on type of battery.
Note
:
Temperature Compensation Sensor Assembly (Part#
ABS-248).
See pages 21 - 2 for full detailed instructions.
3.
Plug the unit’s Power cord into a standard – grounded
220/240 Vac electrical outlet. The Battery Connected LED
Indicator will light
GREEN
. If it does not light
GREEN
check the
outlet to be sure it is functioning. In addition, be sure if outlet is
controlled by a switch, no one will accidentally shut off the power
to the outlet. Check for correct polarity = (no ERROR
RED
LED
Indicator). If ERROR Indicator is lit, reverse the charger’s output
connections to the battery.
4.
Charger will automatically start within 0 seconds or less.
The
Charge – Float LED Indicator will light
GREEN
. The charger will
now begin charging by first checking the battery to determine
its voltage and ability to accept a charge. Should the battery not
have a normal fully discharged voltage (10.5-V minimum) the unit
will begin charging in the “Soft-Start” mode to determine if the
battery can be safely charged. If it cannot, the Battery Connected
– Error LED will flash
RED
and charging will be stopped. Battery
should be carefully checked under a load by a qualified person
before further attempting to charge it.
