3. Snap the Rod into the mounting clips.
4. Make sure the end of the wire has a clean cut end. If it does not, cut off a small amount
of the cord to achieve a clean end. Do not split the wires, see figure 1. The plug housing
has a back cover that will need to be removed, see figure 2. Once the cover is removed, you
will see two prongs, as shown in figure 3. Place the cord into the cavity with the prongs,
making sure that the cord is inserted as far into the housing as possible. Then begin to
reinstall the housing cover, as shown in figure 4 (next page). Make sure the cover is
completely shut, thus locking the cord inside the plug housing, as shown in figure 5 (next
page).
Instructions continued on next page.
5. Plug the Dehumidifier Rod into a power outlet.
Figure 1
Make sure you have a
clean cut end on the wire.
Right
Wrong
Figure 2
Remove the plug housing
cover as shown. Please
note the orientation of this
cover as it will need to be
reinstalled the same way.
Figure 3
Once the cover is removed,
you will see a channel with
two prongs. This is where
the power cord will be
installed.
Prongs
Figure 4
Place the cord in the
channel, making sure the
cord is inserted as far as it
will go. Then replace the
cover as shown.
Figure 5
Make sure the cover is
completely shut, thus
locking the power cord
inside the plug housing
as shown.
Insert power cord all the way.
CAUTION
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT. FULLY INSERT. POUR EVITER LES CHOCS ELECTRIQUIES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE
LA PRISE ET POUSSER JUSQU’AU FOND.
